Tripp Lite 700VA 450W Lithium Ion UPS Smart Tower AVR Hospital Medical 120V SMART700HGL

Tripp Lite SMART700HGL 700VA 450W Lithium Ion UPS Smart Tower AVR Hospital Medical 120V SMART700HGL

Tripp Lite’s SMART700HGL medical-grade UPS system provides dependable lithium iron phosphate (LiFePhos) battery backup, so you can work through short power failures and perform an orderly system shutdown in a prolonged blackout. It’s fully compliant with UL 60601-1 regulations when plugged into a hospital-grade outlet, making it ideal for use in patient-care vicinities. The 700VA/450W capacity provides up to 42 minutes of runtime for a half load and 18 minutes for a full load. Built-in line-interactive voltage regulation corrects brownouts as low as 81V and overvoltages as high as 143V to normal 120V nominal output without drawing battery power. The SMART700HGL’s built-in isolation transformer with Faraday shield offers full isolation and removes common mode noise while maintaining full AC surge suppression in all modes. This UPS system features four NEMA 5-15R-HG hospital-grade outlets and a hospital-grade NEMA 5-15P-HG plug with a six-foot cord for flexibility in placement. All four outlets provide both battery backup and 940 joules of surge protection. The SMART700HGL also features diagnostic LEDs, as well as a USB port and a DB9 serial port that work with Tripp Lite’s free downloadable PowerAlert® software for safe, unattended system shutdown and file saves in the event of a prolonged power failure.

Features:

• 42 min. runtime at half load; 18 min. at full load
• Reduces cumulative leakage current to under 100 ?A
• Floating AC output prevents noise coupling
• 940 joules of surge protection
• 10,000-cycle LiFePhos battery

Specifications:

• Output
• Output Volt Amp Capacity (VA): 700
• Output Watt Capacity (Watts): 450
• Power Factor: 0.6
• Nominal Output Voltage(s) Supported: 115V; 120V
• Frequency Compatibility: 60 Hz
• Output Voltage Regulation (Line Mode): -18%, +8%
• Output Voltage Regulation (Battery Mode): 115V (+/- 5%)
• Output Receptacles: (4) 5-15R
• Output Receptacle Details: Hospital grade output receptacles
• Output AC Waveform (AC Mode): Sine wave
• Output AC Waveform (Battery Mode): PWM sine wave
• Individually Controllable Load Banks: No
  
  Input
• Rated input current (Maximum Load): 5.5A
• Nominal Input Voltage(s) Supported: 120V AC
• UPS Input Connection Type: 5-15P-HG
• Input Circuit Breakers: 10A
• UPS Input Cord Length (ft.): 6
• Recommended Electrical Service: 15A 120V
• Input Cord Length (ft.): 6
• Input Phase: Single-Phase
  
  Battery
• Full Load Runtime (min.): 18 min. (450w)
• Half Load Runtime (min.): 42 min. (225w)
• DC System Voltage (VDC): 36
• Battery Recharge Rate (Included Batteries): Less than 4 hours from 10% to 90%
• Battery Access: Battery access door
• Expandable Runtime: No
  
  Voltage Regulation
• Voltage Regulation Description: Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 81 to 143
• Overvoltage Correction: Input voltages between 126 and 143 are reduced by 9%
• Undervoltage Correction: Input voltages between 96 and 106 are boosted by 10%
• Severe Undervoltage Correction: Input voltages between 81 and 95 are boosted by 21%
  
  Surge / Noise Suppression
• UPS AC Suppression Joule Rating: 940
• UPS AC Suppression Response Time: Instantaneous
• EMI / RFI AC Noise Suppression: Yes
• AC Suppression Joule Rating: 940
• AC Suppression Response Time: Instantaneous
  
  Isolation
• Output Isolation Transformer: Hospital grade load isolation transformer
• Leakage Current: Equal to less than 100 microamps
  
  Physical
• Installation Form Factors Supported with Optional Accessories: Wallmount (UPSWM - tower mounting kit)
• Primary Form Factor: Tower
• UPS Power Module Dimensions (hwd, in.): 12.8 x 7.5 x 9
• UPS Power Mod